Colapso por flexo-torção de colunas de aço formadas a frio sob temperaturas elevadas :resistência última e dimensionamento via MRD
Carregando...
Arquivos
Data
Título da Revista
ISSN da Revista
Título de Volume
Editor
Universidade Federal do Rio de Janeiro
DOI
Resumo
An extensive numerical investigation has been reported with evidence that the current Direct Strenght Method (DSM) global strength curve overestimates the ultimate strength of Cold-Formed Steel (CFS) when submitted to uniform compression under fire situation. This study used ultimate strength of elevated temperatures gathered to propose a new set of flexural torsional curves in each temperature, based on DSM, which are clearly different when the slenderness is below than 1,5. This research, that can be read as a continuation of previously studies, investigate the flexural torsional post-buckling equilibrium paths and the DSM for steel columns that exhibit flexural torsional buckling when submitted to uniform compression under elevated temperatures. The results consist of post-buckling equilibrium paths and ultimate strength, obtained through nonlinear shell finite element analyses. To ensure covering wide slenderness ranges, several room/moderate temperatures (20/100 °C) yield stresses and different columns lengths and variety of transversal sections were considerate. The steel is simulated by models prescribed in Eurocode 3: part 1.2. The numerical failure loads obtained in this research and collected in the international literature were used to validated the efficiency of DSM and to propose a modification, making it capable of handling flexural torsional failures under elevated temperatures.
Descrição
Palavras-chave
Estruturas metálicas , Colunas de aço formadas a frio , Flambagem , Temperaturas elevadas , Situação de incêndio , Método da Resistência Direta , Análise de elementos finitos , Steel structures , Cold formed steel columns , Flexural torsional buckling , High temperatures , Fire conditions , Direct Strength Method , Finite element analysis
Citação
BICELLI, Antonio Renato Albuquerque. Colapso por flexo-torção de colunas de aço formadas a frio sob temperaturas elevadas: resistência última e dimensionamento via mrd. 2021. 130 f. Dissertação (Mestrado) - Programa de Pós-Graduação em Engenharia Civil, COPPE, Universidade Federal do Rio de Janeiro, Rio de Janeiro, 2021.
Coleções
Avaliação
Revisão
Suplementado Por
Referenciado Por
Direitos e licensiamento
Acesso Aberto